UPGRADE PACKAGES

AB PV 600 touch screen operator interface

AB PLC Micro-Logix 1100 with associated Input, Output, Analog and Ethernet modules

Electrical enclosure populated with all associated circuit breakers, fuses, terminal blocks Motor starters, and Main Control relay

New pressure transducers

New water flow sensor

New compressor temperature sensors and display meter

HMI included for:

• Monitoring screen with dynamics tank pressure, dynamic helium % and compressor operating state
• Tank monitoring
• Transducer calibration
• Control panel with cold start, Analyzer calibration and run mode selection

On-site installation available

Provides superior protection for the leak detector and chamber monitoring devices while eliminating the need for expensive sintered metal filters

Reduces high nitrogen purge requirements

Reduces downtime and maintenance costs due to leak detector contamination and particulate exposure

On-site installation available

Ideally suited for non-proof test applications

Provides a two step low pressure and high-pressure helium charge that will allow quick identification of large product leaks preventing helium contamination of the chamber

Chamber purge provides an enhanced gas flow technique used to flush residual helium from the chamber and sample line after gross or fine leaks – allows immediate unaffected testing of subsequent cycles

On-site installation available

Increases quality control

Provides a more accurate measurement of the product charge and evacuation pressures

The existing part pressure transducer will be removed from the current charge cabinet and mounted on the chamber door

VIC will replace the existing part evacuation pump and replace it with an oil-less maintenance free Venturi pump – this includes all associated piping and hardware

All charge cabinet valves will be rebuilt

On-site installation available

Eliminates the requirements for frequent recharges associated with larger calibrators, typically a 10-4 Atm-cc/sec gas leak and larger

Allows a lower gas cylinder charge pressure

Pressure switch input to the existing PLC provides quality assurance that the leak standard is at the required charge pressures

On-site installation available

Increases accuracy of quantified part leaks providing greater quality assurance

Provides part leak rate correction based on dynamic part evacuation and helium charge levels

Ideal for low pressure charge applications i.e. fuel tanks or in production environments where part volumes continually change

On-site installation available

Eliminates operator dependency to correctly calibrate system improving quality control

System automatically captures the background and leak standard values then calculates the accept and reject set points for go/no-go testing

Provides quantified part leak rate results

Reduces the ergonomic problems associated with manual calibration

On-site installation available

New touch-screen HMI

Allows a lower gas cylinder charge pressure

New Electronic package

33% savings off a new unit purchase

Utilizes existing inventory of consumable spare parts

Five-year warranty on Electronics